Today I learned how to assemble a mill. I had to follow a tutorial. There are 9 different kind of parts, there is a knee, table, saddle, bracket, head, scale, pillar, clamp, and a pin. First I had to insert the knee, table and saddle by clicking insert component where all the parts are. Then I had to assemble the knee and the table first then the saddle on top of the table. After that I assembled the bracket on the side of the table and then I assembled the head on top of the bracket. And then I assembled the scale inside of the head. I inserted two pieces of pillars and assembled them in the holes on the side of the saddle. Then I inserted two pieces of clamp and pin. I rotated one of the pins and assembled it with a clamp and assembled it into the pillar on the right side. After that i rotated the second clamp and pin and assembled them together, and then I assembled them into the pillar on the left side. When I assemble the the clamp and the pin into the pillar the scale gets assembled into the pins by itself. It was a hard and complicated assembly.
Ruqia Upward Bound 